LTS Mifare 13.56MHz Key Fob (Grey) - WG34 Access Control Credential

LTS Mifare 13.56MHz Key Fob (Grey)

The LTS Mifare Key Fob is a compact, grey RFID credential designed for use with Mifare-compatible access control readers and LTS IP intercom systems. Built on 13.56 MHz Mifare Classic technology, this durable fob provides a fast, contactless way for staff, tenants, or residents to present credentials at a door reader, turnstile, or intercom panel. Its small keyring-friendly form factor makes it a practical alternative to access cards for everyday carry, while remaining fully compatible with standard Wiegand-based access control controllers.

Key Features

• 13.56 MHz Mifare Classic chip for reliable, fast contactless reads
• Wiegand 34-bit (WG34) output for straightforward integration with most access control panels
• Printed identification number on the fob face for easy manual lookup, auditing, or reissue
• Compact grey ABS housing designed to withstand daily handling and keyring use
• Lightweight, keyring-ready design that's easier to carry than a full-size card
• Compatible with LTS Mifare readers and controllers as well as many third-party Mifare-based access systems
• Works with LTS IP intercom accessory ecosystem for door entry and resident access
• Non-programmable, ready-to-deploy credential with a unique identifier out of the box

Typical Applications

This fob is well suited to office buildings, apartment complexes, gyms, and multi-tenant sites where a simple, low-cost credential is needed for door access or intercom entry. It pairs naturally with LTS access control readers and LTS IP intercom systems, giving installers a matched, tested combination for new or expanding access control deployments. Because it uses widely supported Mifare and Wiegand standards, it can also be issued as a replacement or supplementary credential within many existing third-party access control installations.

What's in the Box

• 1 x LTS Mifare 13.56MHz Key Fob (Grey)

Frequently Asked Questions

Is this fob compatible with non-LTS access control readers?
Yes, as it uses the widely adopted 13.56 MHz Mifare Classic standard with WG34 output, it will generally work with any reader and controller that supports this format.

Can the printed number be used to identify a lost or stolen fob?
Yes, each fob has a printed identification number on its face, which administrators can use to locate and deactivate the credential in their access control software.

Does this fob need to be programmed before use?
No, the fob ships with a fixed unique identifier and is ready to be added to your access control system's credential list without additional programming.