LTS Blanking Cover Plate for LTH-M201-6B 6-Button Intercom Module (Pack of 5)

LTS Blanking Cover Plate for LTH-M201-6B 6-Button Intercom Module

The LTH-M201-6B-C is a purpose-built blanking cover designed to neatly seal off any unused button positions on the LTS LTH-M201-6B six-button nametag module, part of the modular LTH-M201 IP and 2-Wire video intercom door station range. When a building or residence does not require all six directory buttons to be active, these covers keep the fascia looking clean, professional, and free of exposed switch openings, while also helping to block dust, moisture, and insects from entering the module housing.

Key Features

• Purpose-matched fit for the LTH-M201-6B six-button nametag/directory module used in LTS IP and 2-Wire intercom systems
• Clean, finished appearance for any button positions left unassigned on the module face
• Helps maintain weather resistance by covering open button apertures on outdoor-rated door station modules
• Simple snap or clip-in installation that does not require special tools
• Supplied as a multi-pack so installers can cover several unused positions across one or multiple modules
• Compact, low-profile design that sits flush with the surrounding module face plate
• Compatible with LTS modular intercom frames used in apartment, townhouse, and commercial entry applications
• Cost-effective alternative to replacing an entire nametag module when only partial button usage is needed

Typical Use Cases

This blanking cover is most useful on multi-tenant or commercial door entry installations where the LTH-M201-6B module has been installed to allow for future expansion, but not all six directory buttons are currently assigned to a resident, office, or unit. Installers can fit the covers over the inactive button slots during commissioning, giving the finished intercom panel a tidy, fully populated look and reducing the chance of dirt or moisture ingress at unused openings, all while leaving the option to swap in a labelled nametag button later if the building's occupancy changes.

What's in the Box

• Blanking cover plates for unused buttons (pack of 5)
• Covers sized specifically for the LTH-M201-6B module button apertures

Frequently Asked Questions

Q: Will this cover fit any LTS intercom module?
A: No, the LTH-M201-6B-C is designed specifically to fit the button openings on the LTH-M201-6B six-button nametag module used in LTS's modular IP and 2-Wire intercom systems.

Q: How many covers come in a pack?
A: These blanking covers are sold as a pack of five, giving installers enough pieces to cover multiple unused button positions on one or more modules.

Q: Can I remove the cover later if I need to activate that button?
A: Yes, the cover can be removed and a nametag button fitted in its place if the property's occupancy or naming requirements change in the future.